Please review the following cautions and warnings.
Environmental speci cations
Operating temperature: Refer to the product datasheet
If you install your Fortinet product in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore, make sure to install the equipment in an environment
compatible with the manufacturer’s maximum rated ambient temperature.
Storage temperature: Refer to the product datasheet
Humidity: Refer to the product datasheet
Air fl ow: For rack installation, make sure that the amount of air fl ow required for safe operation of the equipment is not
compromised.
For free-standing installation, make sure that the appliance has at least 1.5 in. (3.75 cm) of clearance on each side to allow for
adequate air fl ow and cooling.
FCC Compliance
Your Fortinet product complies with either FCC Class A or FCC Class B rules.
The Fortinet product has been tested and found to comply with part FCC Class A, Part 15, UL/CUL, C Tick, CE and VCCI.
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
The Fortinet product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for uncontrolled environments.
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to your local regulations.
Grounding
Ensure your Fortinet product is connected and properly grounded to a lightning and surge protector. WAN or LAN connections that enter
the premises from outside the building should be connected to an Ethernet CAT5 (10/100 Mb/s) surge protector.
Shielded Twisted Pair (STP) Ethernet cables should be used whenever possible rather than Unshielded Twisted Pair (UTP).
Do not connect or disconnect cables during lightning activity to avoid damage to your Fortinet product or personal injury.
Electrostatic discharge (ESD) can damage Fortinet equipment. Only perform the procedures described in this document from
an ESD workstation. If no such station is available, you can provide some ESD protection by wearing an anti-static wrist strap
and attaching it to an available ESD connector or other bare metal object.
8. Cautions and Warnings
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais